# iWay

Recently we where connected by [swl](https://www.swl.ch) to the fiber network and I switched from [upc](https://www.upc.ch), finally getting rid of the enforced router, finally the aera of synchonous connectivity started. 
## SG300-10
[![sg300](https://naumann.dev/uploads/images/gallery/2019-12/scaled-1680-/IMG_20191218_055354.jpg)](https://naumann.dev/uploads/images/gallery/2019-12/IMG_20191218_055354.jpg)
The setup is refreshingly simple, I added an SFP modul (FLEXOPTIX S.B1312.10.XDL) to the Cisco SG300-10 switch I used before, that was all. With my new provider [iWay](https://www.iway.ch) it was not even necessary to configure a specific VLAN. 

On there [website](https://kb.iway.ch/pages/viewpage.action?pageId=12256645) they say you need a `Simplex TX 1310nm/RX 1490nm BiBi SFP` Module.

The SFP module is connected to port 9 on the switch, port 10 goes to my [OPNsense](https://opnsense.org/) router. 
Ports 9 and 10 are on the same VLAN, just via access ports to separate the traffic. 
[![sg300 vlans](https://naumann.dev/uploads/images/gallery/2019-12/scaled-1680-/Screenshot-from-2019-12-18-06-16-58.png)](https://naumann.dev/uploads/images/gallery/2019-12/Screenshot-from-2019-12-18-06-16-58.png)
Port 8 gets internet from the router and distributes it to port 4, my office switch.
## OPNsense WAN
This is the WAN configuration I use
[![WAN](https://naumann.dev/uploads/images/gallery/2019-12/scaled-1680-/Screenshot_2019-12-18-[WAN]-Interfaces-open01-home.png)](https://naumann.dev/uploads/images/gallery/2019-12/Screenshot_2019-12-18-[WAN]-Interfaces-open01-home.png)